EVO-ALL firmware 79.69 push to start non-hybrid. Flashed with the recommended settings using the wizard and verified current settings: A1:A10 = on, A11 = off, A12 = on, A13:B3 = off, C1:D1 = on, D2:D5 = off, D6 = on, D7:G = off, H2 = on (for the RFK912 install). First attempt at installation, bypass was programmed successfully and 3x lock started the vehicle. Once I programmed the two RFK912 remotes, the vehicle would not turn on with the remotes. Reset the unit using master reset procedure (red light and hold until all colors flash) and reflashed the unit and ram the decryptor. Nothing worked on the second try but the unit recognizes when I press the RFK912. Vehicle starts and runs normally using the push button start. Ran through master reset, reflash, and decryptor a few times with the same results. Now I am getting a decryptor limit reached error for SN 001A07 272320. Please help - this is my second install on a RAV4 of the same year and the first install went flawlessly.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
